Tronic KH 3906 Operating Instructions Manual

Voltage transformer

Advertisement

6
VOLTAGE TRANSFORMER
KH 3906
VOLTAGE TRANSFORMER
Operating instructions
KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM
www.kompernass.com
ID-Nr.: KH3906-10/09-V2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KH 3906 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Tronic KH 3906

  • Page 1 VOLTAGE TRANSFORMER KH 3906 VOLTAGE TRANSFORMER Operating instructions KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM www.kompernass.com ID-Nr.: KH3906-10/09-V2...
  • Page 2 KH 3906...
  • Page 3: Table Of Contents

    CONTENT PAGE Correct Usage Safety information Technical data Operating Elements Initial operation Operational information Connection and operation of a load/device Device operation information Low battery signal Handling general failures Troubleshooting Cleaning Disposal Importer Warranty & Service Read the operating instructions carefully before using the device for the first time and preserve this booklet for future reference.
  • Page 4: Correct Usage

    VOLTAGE Safety information TRANSFORMER KH 3906 • This device is not intended for use by individuals (including children) with restricted physical, Correct Usage physiological or intellectual abilities or who are lacking in experience and/or knowledge unless The device is intended for connection to a 12 V in...
  • Page 5: Technical Data

    Technical data Risk of fire! • Do not use the device near hot surfaces. • Do not locate the device in places exposed to DC Input direct sunlight, Otherwise, it may overheat and become irreparably damaged. Do not operate Voltage: the device in a vehicle that is standing out in the sun.
  • Page 6: Operating Elements

    Operating Elements The required power needed for operation can be calculated as follows: Fan (on the rear panel) 12 V vehicle plug On/Off switch AC socket Operation LED/Overload indicator Example Initial operation The power source should also supply at least 14,7 A. Unpacking Attention! 1.
  • Page 7: Connection And Operation Of A Load/Device

    Connection to a voltage source • Now switch on the load/device to be operated. When switched on a short signal tone can be Attention! heard. Before connecting the power inverter to a vol- Note: tage source make sure that the on/off switch on the device is in the position 0.
  • Page 8: Low Battery Signal

    Television sets • Inductive loads, for example, televisions or stereo systems (devices with an inductor or a transformer) • The power inverter is shielded and puts out a fil- often require a much greater switch on current tered sine wave. With the reception of, for example, than resistance loads with the same specified very weak television stations it can, nevertheless, wattage.
  • Page 9: Cleaning

    No output power Cleaning the housing: Clean the housing surface with a slightly damp Possible cause and remedy: cloth Never use benzene, solvents or detergents • The power inverter is not fully warmed up. that can damage plastics! Switch the power inverter on and off again until In the event that the ventilation slots become dusty the device attached to the power inverter is you can clean these with a soft brush.
  • Page 10: Warranty & Service

    Warranty & Service The warranty for this appliance is for 3 years from the date of purchase. The appliance has been ma- nufactured with care and meticulously examined be- fore delivery. Please retain your receipt as proof of purchase. In the event of a warranty claim, please make contact by telephone with our Service Depart- ment.

Table of Contents