Troubleshooting - CYBEX 70T Console Owner's Manual

Troubleshooting

Malfunction
No Power.
Treadmill striding belt
slips off-center.
Maximum treadmill
speed is reduced.
Rubbing sound comes
from underneath
treadmill.
Display does not
illuminate when
machine is powered on.
Troubleshooting the Polar
Heart rate reading is erratic or absent entirely
Probable Cause
Belt transmitter electrodes are not wet enough to pick up
accurate heart rate readings.
Probable Cause
ON / OFF switch is not in proper position.
Power source is insufficient.
Line cord is damaged.
Line cord is improperly seated in socket.
NOTE: Treadmills only: You may be in "Energy
Saving Mode".
NOTE: Arc Trainers and Bikes only: You may be in
"Energy Saving Mode".
Floor surface is uneven.
User is pushing striding belt. This occurs when the
runner is running faster than the striding belt will
travel, with the result of the striding belt being
pushed with the runner's feet.
User is stalling striding belt. This will occur with
heavier users at lower striding belt speeds. The
striding belt will "stall" if the user is traveling slower
than the striding belt speed.
Striding belt/deck malfunctions. The deck laminate
is worn through or the underside of striding belt is
glazed over (hard, glossy).
Power source is insufficient.
Foreign objects may be stuck underneath the
machine.
Loose connection at display console or motor
control board.
® Heart Rate Chest Strap
Corrective Action
Turn the switch to the ON position.
Plug treadmill into a dedicated 20 amp circuit.
Using a voltmeter, verify power at outlet. If no
power exists, reset circuit breaker at panel.
Replace line cord.
Services.
Inspect power connection at wall outlet and at
machine for proper contact.
Treadmill will go into Energy Saving Mode after 5
minutes of inactivity. To wake the console, step on
the treadmill belt. The treadmill will automatically
wake and the console will light up. Waking up the
treadmill takes approximately 50 seconds after
stepping onto the belt.
Unit will go into Energy Saving Mode after 5 minutes
of inactivity. To wake the console, pedal until you
hear a beep. The unit will automatically wake and
the console will light up. Waking the unit takes
approximately 50 seconds after beginning to pedal.
Check levelers and level treadmill. Check striding
belt and re-tension as necessary. Refer to Treadmill
and Bike Assembly Instructions.
Instruct users not to push striding belt in either
direction.
Replace belt and deck.
Support Services.
Plug treadmill into a dedicated 20 amp circuit.
Inspect underneath striding belt and machine.
Remove any debris or objects that may cause
interference with the treadmill.
Check all electrical connections for proper
attachment.
Services..
Corrective Action
Wet the belt transmitter electrodes.
Page 75 of 80
Contact Cybex Customer Support
Contact Cybex Customer
Contact Cybex Customer Support