Table of Contents
Advertisement
Installation
Step 1 - Set the RF ID # rotary switch on the bottom of the MRF-300 to a
VALID ID# (any address other than ID# 0). If you leave it set to ID# 0, the MRF-300
operates with some restrictions:
a. Accepts RF signals from any 418MH
the address set when programming the remote control.
b. Front Blaster will be OFF and all IR line outputs are set to ALL).
Slide off the mounting plate to reveal the RF ID# rotary switch. Use a small flat blade
screwdriver to set the RF ID# to the address you used when programming the remote
control (1-9 or A-F are valid addresses, while 0 is not a valid address).
Step 2 - Mount or place the MRF-300 conveniently and run flashers
to each component's front panel sensor or connect the Line Out to
a components rear panel IR Input.
MRF-300 B
S
ASE
TATION
Page 3
remote control regardless of
Z
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MRF-300/RFX150 and is the answer not in the manual?
Questions and answers