Inserting Batteries; Installing The Remote Control Holder - LG SM282CE NE1 Owner's Manual

Inserting batteries

Insert batteries before using the remote
control. The battery type used is AAA (1.5 V).
1
Remove the battery cover.
2
Insert the new batteries and make sure
that the + and - terminals of the batteries
are installed correctly.
3
Reattach the battery cover.
!
NOTE
If the display screen of the remote control
starts to fade, replace the batteries.

Installing the remote control holder

Install the holder where there is no direct sun-
light to protect the remote control.
1
Choose a safe and easily-accessible place.
2
Fix the holder by double-side tape.
3
Slide the remote control into the holder.
CAUTION
!
• Press only button at a time. (Pressing
multiple buttons simultaneously will not
work.)
• Do not step on or apply strong impact to
the remote controller.
• Do not use the remote controller in wet
or humid locations.
• Do not use the remote controller near
heater or in hot location.
• The remote controller may not receive
the signal in locations with strong light
such as 3 wave florescent light or neon
sign. In cases like these, use the remote
controller in front of the remote con-
troller receiver of the indoor unit.
• If the remote controller is not used for a
long period of time, the liquid in the bat-
tery can leak to cause an error. There-
fore take out all batteries from the
remote controller to store the remote
controller.
• When replacing the battery, always re-
place both batteries with new ones and
if the remote controller does not work
even after replacing the batteries, re-
quest for service.
• Do not disassemble or recharge used
batteries, and do not dispose the batter-
ies in the furnace or hot location. It can
cause an explosion.
BEFORE USE
13
Double-side
tape