Table of Contents
Advertisement
Atlas DVR-PVR M1055
CHECKING THE CODES
If you have set up the Atlas DVR/PVR 5-Device Universal
Remote Control using the Searching For Your Code
procedure (on the previous page), you may need to find
out which four-digit code is operating your equipment.
For example, to find out which code is operating your TV:
On the remote control, press TV once; it will
1.
blink once. Then press and hold SETUP until
the TV key blinks twice, then release SETUP.
2.
Enter 9 - 9 - 0. The TV key will blink twice.
3.
To view the code for the first digit, press 1
once.Wait 3 seconds and count the number
of times the TV key blinks (e.g., 3 blinks = 3)
and write down the number in the leftmost
TV Code box on page 11.
NOTE: If a code digit is "0", the selected mode key
will not blink.
4.
Repeat step 3 three more times for the
remaining digits. Use 2 for the second digit,
3 for the third digit, and 4 for the fourth digit.
Finish writing down the code in the TV Code
boxes on page 11.
5.
To check for other device codes, repeat steps
1 through 4, but substitute the appropriate key
(e.g., AUX, DVD, AUD, or CBL) for the device
you are checking.Write down the codes in the
appropriate boxes on page 11.
8/12/04
4:51 PM
Page 14
14
Advertisement
Table of Contents
