Re-Assigning Device Keys - Universal Electronics MILLENNIUM 4 User Manual

Millennium 4 Mnl M4094 rev

RE-ASSIGNING DEVICE KEYS

The Millennium 4 can be set up to control a second TV
or VCR, or any combination of four home entertainment
components. For example, to have the Millennium 4
control a TV, a Cable Converter, and two VCRs, you will
need to re-assign the unused AUDIO key to operate the
second VCR as follows:
1. On the Millennium 4, press and hold SETUP
until the LED blinks twice, then release SETUP.
Enter 9 - 9 - 2. The LED will blink twice.
2.
3. Press VCR once, then press AUDIO once.
4. The AUDIO key is now ready to be programmed
for your second VCR. See Programming
VCR/DVD Player Control on page 12.
To re-assign other device keys, repeat steps 1 through 4 by
substituting the key sequence from the following chart for
a desired component:
To Re-Assign
TV as 2nd VCR key:
TV as 2nd Audio key:
TV as 2nd Cable key:
TV back to TV:
VCR as 2nd TV key:
VCR as 2nd Audio key: SETUP - 9 - 9 - 2 - AUDIO - VCR
VCR as 2nd Cable key: SETUP - 9 - 9 - 2 - CBL - VCR
VCR back to VCR:
AUDIO as 2nd TV key: SETUP - 9 - 9 - 2 - TV - AUDIO
AUDIO as 2nd VCR key: SETUP - 9 - 9 - 2 - VCR - AUDIO
AUDIO as 2nd Cable key: SETUP - 9 - 9 - 2 - CBL - AUDIO
AUDIO back to AUDIO: SETUP - 9 - 9 - 2 - AUDIO - AUDIO
Upon completion of a re-assignment, the LED will blink
twice to confirm your selection.At that time, you will also
need to program the Millennium 4 to control the new
component. See previous sections on Programming TV
Control, Programming VCR/DVD Player Control,
Programming Cable Converter (or DBS Receiver) Control,
or Programming Audio Control.
12/27/02 11:00 AM
Perform Key Sequence
SETUP - 9 - 9 - 2 - VCR - TV
SETUP - 9 - 9 - 2 - AUDIO - TV
SETUP - 9 - 9 - 2 - CBL - TV
SETUP - 9 - 9 - 2 - TV - TV
SETUP - 9 - 9 - 2 - TV - VCR
SETUP - 9 - 9 - 2 - VCR - VCR
27
Page 27