Benelli RFS150i Manual page 21

vertically to the ground.
3. Stop the engine for 2-3 minutes and then take
the oil dipstick out of the oil hole and clean it. Insert
the oil dipstick back into the oil hole (but not screw
in). Oil level shall be between the top point and the
lowest point.
4. Injecting too much oil into the engine is forbid-
den.
5. Install the oil dipstick and check if there is leak-
age somewhere.
Max
Min
NOTICE
The engine oil should be between the minimum
and maximum level marks.
TO CHANGE THE ENGINE OIL
1. Start the engine, warm it up for several minutes,
and then turn it off.
2. Place an oil pan under the engine to collect the
used oil.
3. Remove the engine oil filler cap and the engine
oil drain bolt to drain the oil from the crankcase.
4. Install the washer and the engine oil drain bolt,
and then tighten the drain bolt to the specified
torque.
5. Refill with the specified amount of the recom-
mended engine oil, and then install and tighten the
oil filler cap.
API SH, SAE10W40, JASO MA
20
Type
Capacity
1.1L ± 0.1L