Benelli RFS150i Manual page 11

High & Low Beam Switch
Turn the switch to " " position, the high beam of
headlamp turn on and the indicator lamp on the
meter would also turn on; turn the switch to "
position, the low beam of headlamp turns on.
Direction Indicator Lamp Switch
Turn the switch to " " position, the left direction
signal lamp flashes; turn the switch to "
the right direction signal lamp flashes. And the indi-
cator lamps would turn on accordingly.
!
WARNING
Turn on the direction signal lamps in time when
changing the driveway or turning a direction
and turn off the lamps.
Passing Switch
(IF EQUIPPED)
When passing other vehicles, press this button so
the high beam of the headlight would flash to alarm
the vehicles in front of you.
Horn Switch
Press down on the button, to activate the horn.
"
" position,
v
Clutch lever switch
(IF EQUIPPED)
When starting the engine or shifting, pull the clutch
lever to cut off driving on the rear wheel.
Engine Stop Switch
When the switch is on "
is on, the engine runs.
When the switch is on "
is off.
Light Switch
(IF EQUIPPED)
Turn switch to position of "
lamp; Turn to " " to light up meter lamp, city
light and tail lamp; turn to "●" for daytime driving.
Hazard Switch
Push the switch to " " position the four direction
signal lamps would flash to warn for emergency
situation
Electric Starter Button
When the transmission is at neutral gear position,
set ignition switch at "
electric starter button"
engine is started.
" position and the power
" position and the power
" to light up the front
" (ON) and press down
" . Motor will run and