PureStorage FlashArray //X R2 Quick Installation Manual page 6

9. Sign into FlashArray and Configure Controllers (Cont'd)
Verify Setup and Configuration
After the FlashArray is online, make sure it is healthy by doing the following:
1. Enter the purehw list command. All statuses should read ok.
2. Enter the hardware_check.py command. All results should be All's well.
3. Enter the pureboot list command. Make sure that *--> is pointing at the desired version.
4. Enter the purearray list --controller command. Make sure both controllers are online and running the cor-
rect version of Purity.
5. Test the Purity GUI by viewing the virtual IP (VIP) in a browser.
6. Test the Purity CLI by using ssh pureuser@array_VIP.
7. If the array has one or more DirectFlash shelves or expansion shelves, enter the following commands on each con-
troller to check the SAS connections:
storage_view.py config
storage_view.py enclosures
If the SAS cables are connected correctly, these commands return the following response:
No errors detected.
If errors are detected, contact Pure Storage Technical Support for assistance.
To disable root and puresetup users, enter the purearray enable console-lock command. To re-enable
these users, enter the purearray disable console-lock command.
Configure Pure1
Refer to the software documentation at the Pure Storage Community site for more information.
© 2018 Pure Storage, Inc. All rights reserved. Pure Storage, Pure1, and the Pure Storage logo are trademarks or registered trademarks of Pure Storage, Inc. in the
U.S. and other countries. Other company, product, or service names may be trademarks or service marks of their respective owners.
The Pure Storage products described in this documentation are distributed under a license agreement restricting the use, copying, distribution, and decom-
pilation/reverse engineering of the products. The Pure Storage products described in this documentation may only be used in accordance with the terms of the license
agreement. No part of this documentation may be reproduced in any form by any means without prior written authorization from Pure Storage, Inc. and its licensors, if
any. Pure Storage may make improvements and/or changes in the Pure Storage products and/or the programs described in this documentation at any time without
notice.
THIS DOCUMENTATION IS PROVIDED "AS IS" AND ALL EXPRESS OR IMPLIED CONDITIONS, REPRESENTATIONS AND WARRANTIES, INCLUDING ANY
IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NONINFRINGEMENT, ARE DISCLAIMED, EXCEPT TO THE
EXTENT THAT SUCH DISCLAIMERS ARE HELD TO BE LEGALLY INVALID. PURE STORAGE SHALL NOT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES IN CONNECTION WITH THE FURNISHING, PERFORMANCE, OR USE OF THIS DOCUMENTATION. THE INFORMATION
CONTAINED IN THIS DOCUMENTATION IS SUBJECT TO CHANGE WITHOUT NOTICE.
Pure Storage, Inc., 650 Castro Street, Suite 260, Mountain View, CA 94041.
http://www.purestorage.com. Direct comments to DocumentFeedback@purestorage.com.
40-0154-01
FlashArray
Page 6 of 6
Quick Installation Guide
October 12, 2018