Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for sky rider Pegasus
Summary of Contents for sky rider Pegasus
- Page 1 Pegasus Quadcopter Drone with Wi-Fi Camera User’s Guide for Model DRW610 v2326-01...
- Page 2 Warnings & Precautions Important Safety Instructions • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and • Read and follow all instructions. receiver. • Keep these instructions for future reference. • Connect the equipment into an outlet on a circuit •...
-
Page 3: Table Of Contents
Table of Contents Pegasus Wi-Fi Drone Sky Rider Flight App FAA Information: Flying Your Drone Under Free Download – 16 the Special Rule for Model Aircraft – 4 Connect to Wi-Fi – 16 Features – 4 Settings Screen – 17 Includes –... -
Page 4: Pegasus Wi-Fi Drone
• 2.4GHz remote control: requires 4 AA batteries (not included) • Altitude hold • Rechargeable lithium polymer battery • Free Sky Rider Flight app • Detachable smartphone cradle • Adjustable angle Wi-Fi camera • 4 rotor guards and screws • 3 speeds •... -
Page 5: Diagram & Specifications
Diagram & Specifications • Dimensions: 280x280x120mm/11x11x4.72 in. (LWH) • Weight: 191g/6.73oz/0.42lb Battery Compartment (rear) Rotor Guard Rotor Landing Skid LED Lights Blue LEDs indicate the front of the craft. Red LEDs indicate the rear of the craft. Camera Power Switch located next to the camera. -
Page 6: Assembly
Assembly Rotor Guards Attach each rotor guard as shown, then tighten with a screw in the center location using the included screwdriver. Landing Struts Place each landing strut on the underside of the craft as shown and press firmly into place, then tighten with included screwdriver and screws. Camera Adjustment Rotate the camera lens by hand to change the viewing angle. -
Page 7: Remote Control
Remote Control Functions 1. Speed Setting 4. Right Control Stick Press to set low/med/high speed. Pitch: push forward/backward Roll/Bank: push left/right Remote will chime to indicate setting. Trim Reset: press control stick 2. Flip Press to perform a flip. 5. Yaw Trim 3. -
Page 8: Battery Installation
Remote Control Battery Installation 4x AA batteries (not included) -
Page 9: Charging The Battery
Charging the Battery Information & Procedure The craft’s battery must be charged before it can be flown. To avoid risk of injury or damage, be sure the craft and remote control are both powered OFF and remove the battery from the craft when charging. Charging time is approximately 120-180 minutes. Charge fully before use for best performance. -
Page 10: Flying
Flying Remote Link & Calibration Before flying, the craft and the remote must be linked together and the gyroscopes on the craft must be allowed to calibrate. Begin with the battery installed, the battery compartment closed, and the craft and remote powered OFF. -
Page 11: Flight Controls
Flight Controls Pitch Altitude Roll Roll Pitch Altitude Left Stick controls Altitude Right Stick controls Pitch (forward/ (throttle) and Yaw (spin). backward) and Roll (left/right). When You’re Finished Flying After landing, keep the Left Control Stick (throttle) in the lowest position and wait for the rotors to stop spinning. -
Page 12: Setting Trim & Countering Drift
Flying Setting Trim & Countering Drift Even after the craft is calibrated, it may show a tendency to drift while airborne. Adjusting the trim will help counter this effect and allow better control of the craft. To avoid potential damage, adjust the trim while attempting a stable hover. Try to avoid making any exaggerated movements with the flight controls and adjust one trim setting at a time to avoid confusion. -
Page 13: Gyroscope Recalibration
Craft drifts left or right. Adjust Roll Trim. Gyroscope Recalibration Remote Trim Reset If the craft is having difficulty flying or is If you are still having difficulty flying, it may behaving erratically, its gyroscopes may help to reset the trim adjustments on the need to be recalibrated. -
Page 14: Tips For Safe Operation
Flying Tips for Safe Operation • It is recommended to only fly in large, open spaces that are free of obstacles like power lines, trees, ceiling fans, etc. • When flying indoors avoid walls and ceilings, as the craft may be drawn towards them if closer than 2-3 feet. -
Page 15: Flips
Flips Before attempting a flip, be sure that there is enough clear space around the craft, ideally 9-10 ft. in all directions. It is not recommended to attempt to flip around or through any obstacles, as this may result in unintended damage. Press the Flip button to activate Flip Mode, then move the Right Control Stick in any direction and the craft will perform a flip in the same direction. -
Page 16: Sky Rider Flight App
Free Download Scan the appropriate QR code with your smartphone or search for Android “Sky Rider Flight” in the Apple App Store or Google Play Store. Connect to Wi-Fi NOTE: Wi-Fi control may be interrupted by interference from other nearby Wi-Fi equipment. -
Page 17: Settings Screen
Settings Screen Flight Parameters About Auto Save Parameters - Trim settings Software Version - Displays software adjusted in the app will be saved for future version number. flights. Be sure to reset the parameters before flying a different craft with the app. Reset Fine Tune Parameters - Reset trim settings to default. -
Page 18: Screen Controls
Sky Rider Flight App Screen Controls 1. Back to Home Screen 6. Speed Setting 10. 3D View (VR Mode) 2. Take Photo 7. Flight Controls ON/OFF 11. Headless Mode 3. Record Video 8. More Controls 12. Gyro Calibration (displays buttons 9-12) 4. -
Page 19: Flight Controls
Flight Controls 1. Throttle/Yaw Control 5. Pitch Trim (tap arrow once to adjust) 2. Pitch/Roll Control 6. Emergency Stop 3. Yaw Trim (tap arrow once to adjust) 7. Take Off 4. Roll Trim (tap arrow 8. Land once to adjust) Altitude Hold/Hover Controls NOTE: This drone must have the Altitude Hold/Hover control enabled to fly. -
Page 20: Using The Remote & App Together
Sky Rider Flight App Using the Remote & App Together It can be easier to capture photos and video by using the remote to fly the drone and using the app in a viewing only method. Use the app and the remote together by attaching the smartphone holder (included) to the remote and placing your phone in the holder. -
Page 21: 3D Mode
3D Mode VR Mode splits the phone’s screen for use in a VR headset. Press the 3D button on the screen to turn this feature ON or OFF. Use VR Mode to give a friend a fully immersive, point- of-view flying adventure. NOTE: •... -
Page 22: Parts & Repair
Parts & Repair REMINDER: Pilots are responsible for any damage caused by improper use. Parts Replacement Standard parts such as extra batteries and remotes are available online for purchase when in stock. However, any non-standard parts such as cameras, screws, bodies, etc. can be ordered by placing an inquiry with our parts department at: partsinfo@dpiinc.com. -
Page 23: Troubleshooting
Troubleshooting Troubleshooting Guide PROBLEM POSSIBLE CAUSES SOLUTION Craft does not • No power to remote • Check remote batteries, or craft. replace if needed. respond to controls. • Poor contact between • Check craft battery, be power plugs. sure it is fully charged. •... -
Page 24: Customer Support
Customer Support Contact Information Warranty Website: www.gpx.com See included 30 Day Warranty for warranty information. Warranty and the most up-to- Email Support: prodinfo@dpiinc.com date version of this User’s Guide can also be found at: www.gpx.com Email Parts: partsinfo@dpiinc.com Phone Support: 1-888-999-4215 International Support To download this User’s Guide in English, Spanish, and French, or to get answers to frequently asked questions, visit the support section at: www.gpx.com...