Stihl BT 45 Instruction Manual page 8

English
As soon as the engine is
running, the power
machine generates toxic
exhaust gas. These
gases may be odorless
and invisible and may
contain unburned hydro-
carbons and benzene.
Never run the engine
indoors or in poorly venti-
lated locations, even if
your model is equipped
with a catalytic converter.
To reduce the risk of serious or fatal
injury from breathing toxic fumes,
ensure proper ventilation when working
in trenches, hollows or other confined
locations. This reduces the risk of
serious or fatal injury from breathing
toxic fumes.
Stop work immediately if you start
suffering from nausea, headaches,
impaired vision (e.g. your field of vision
gets smaller), impaired hearing,
dizziness, or impaired concentration –
these symptoms may possibly be the
result of too-high exhaust gas
concentration – Risk of accidents!
Operate your power tool so that it
produces a minimum of noise and
emissions – do not run the engine
unnecessarily, accelerate the engine
only when working.
Dust (e.g. wood dust), fumes and smoke
may be produced while working may be
hazardous to health! Wear a dust mask
in case of dust formation.
No smoking when working with or near
the machine – risk of fire! Combustible
fuel vapor may escape from the fuel
system.
6
If your power tool is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work – see also
"Before Starting". Check in particular
that the fuel system has no leaks and the
safety equipment is fully operative.
Never use a power tool that is no longer
safe to operate. In case of doubt, contact
a dealer.
Do not operate your power tool in the
starting throttle position – engine speed
cannot be controlled in this position.
Only touch the drill and the drill spindle if
the engine is stopped and the gear stick
is in idle position (position N) – Risk of
injury!
Avoid contact with lines
carrying electrical cur-
rent – Risk of electrical
shock!
Hold the machine firmly so that sudden
jolts can be absorbed – only apply a
small amount of pressure when drilling.
Take particular care when working in
stony areas or ground with roots.
Cover drilled holes and make safe.
To change the drilling tool, stop the
engine and put the gear in idle position
(position N) – Risk of injury!
Do not touch machine parts, particularly
the muffler – Risk of burn injuries.
Before you leave the machine: Shut the
engine off.
Regularly check that the auger is in
perfect working condition. Replace
damaged or blunt augers immediately.
Vibrations
Prolonged use of the power tool may
result in vibration-induced circulation
problems in the hands (whitefinger
disease).
No general recommendation can be
given for the length of usage because it
depends on several factors.
The period of usage is prolonged by:
Hand protection (wearing warm
–
gloves)
Work breaks
–
The period of usage is shortened by:
Any personal tendency to suffer
–
from poor circulation (symptoms:
frequently cold fingers, tingling
sensations).
Low outside temperatures.
–
The force with which the handles
–
are held (a tight grip restricts
circulation).
Continual and regular users should
monitor closely the condition of their
hands and fingers. If any of the above
symptoms appear (e.g. tingling
sensation in fingers), seek medical
advice.
Maintenance and Repairs
Service the machine regularly. Do not
attempt any maintenance or repair work
not described in the instruction manual.
Have all other work performed by a
servicing dealer.
BT 45