Table of Contents
Advertisement
Then the radiometer is mounted in the CVF4 and levelled with its own levelling feet. Afterwards the
radiometer mounting screws and shoulder washers are fitted (not secured yet).
In case the CVF4 is mounted on a solar tracker, finish the alignment of the tracker first before securing the
radiometer screws because tracker (and radiometer) levelling might need re-adjustment.
After all mounting screws have been secured the cables of the CVF4 and the radiometer can be connected.
The radiometer cable goes (down) through the slit in the CVF4 base plate.
Finally the CVF4 cover can be put on and the two cover nuts can be fastened.
Make sure the cover is horizontal (check equal space around the radiometer dome) and the two cover nuts
are fastened hand tight.
SOLYS2 with top mounting plate and 3 x CVF4
SOLYS2 with small top mounting plate with CVF4
9
Advertisement
Table of Contents
