To Operate Uh073Sx In Duplex Mode; Scanning; Open Scan (Os) Mode (The Absence Of Gs Icon Indicates That The Unit Is On - Uniden UH073sx Operating Manual

TO OPERATE uh073sx IN DUPLEX MODE

Eg. CH01 is being used in your area for repeater use.
Press dup momentarily. The DUP icon appears.
dup
Press again to deactivate the duplex operation.
uh073sx will return to simplex operation.
Check with your local retailer for available repeaters.

SCANNING

The uh073sx has two types of scanning; Open Scanning (OS) and Group
Scanning (GS).
Scanning allows you to search for active channels
programmed in the OS or GS memory.
To initiate scanning;
1. Assuming the unit is on CH17 when switched on.
2. Press scan and scanning starts. Scan icon flashes during scanning.

Open Scan (OS) Mode (the absence of GS icon indicates that the unit is on

OS mode)
Allows continuous scanning of channels stored in the Open Scan (OS) memory.
If an active channel is found, scanning will stop on that channel.
The factory has preprogrammed all the 40 UHF channels into the
Open Scan channel memory. However, you can change or
customize the channels by following the steps on programming
Scan Channels on page 15.
Example: CH40 becomes active
If the received signal cease, the unit will wait for at least 3 seconds for the
signal to return, otherwise scanning resumes.
To skip the active channel, press
To deactivate SCAN, press
momentarily. Scanning resumes.
mem
PTT
or .
scan
13