Color profile: Disabled
Composite
Default screen
TO OPERATE IN DUPLEX MODE
Duplex mode is only available from CH01 – CH08. Duplex
mode is activated on a per channel basis and transmitting
frequency on Duplex channels is CH31 – CH38. E.g., If the
Repeater channel for your area is CH01, then while in Duplex
mode the Transmit channel will become CH31
with the Receive channel being CH01.
Press
momentarily. The
dup
appears.
Press
again to deactivate the duplex
dup
operation.
UH041/UHO41P
normal operation.
Note: If
is pressed when the channel is
dup
not from CH01 - CH08, an error tone sounds.
SCANNING
The scan function scans all channels and stops at an active
channel. When the signal stops, the
seconds (Reply Delay) before scanning resumes.
To initiate scanning,
1. Assuming the unit is on CH01
when switched on.
2. Press and hold Channel
for 3 seconds and scanning starts
and Scan icon is displayed.
3. Press
or
scanning.
If Channel
paused on a channel, scanning is resumed.
UH041 Manual.prn
UH041 Manual - UT01912AZ
Monday, October 13, 2003 6:52:28 PM
'DUP'
will return to
or
to cancel
PTT
or
is pressed while the unit is
7
icon
UH041/UHO41P
SCAN
hi/lo
dup
channel/
scan
DUP
waits 2
mon
volume