Operation; Before Turning Gas Supply On; Before Lighting; Lighting - Blue Rhino Endless Summer 153300 Owner's Manual

WARNING
FOR YOUR SAFETY:
If at any time you are unable
to light pilot and smell gas,
wait 5 minutes to allow gas to
dissipate before attempting to
light heater.
WARNING
FOR YOUR SAFETY:
Do NOT touch or move heater for
at least 45 minutes after use.
Allow all burner elements to cool
before touching.
View Hole
LOW LOW
HIGH
HIGH
LOW LOW
HIGH HIGH
13
Pilot Pilot
(Push in)
OFF OFF
Pilot Pilot
(Push in)
OFF OFF
Owner's manual and assembly instructions: model 153300 outdoor patio heater
Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.

Operation

Caution: Do NOT attempt to operate heater until you have read and
understand all precautions in section 1 "Safety First."

Before Turning Gas Supply ON

• Your heater was designed and approved for outdoor use only. Do
NOT use it inside a building, garage, or any other enclosed area.
• Disconnect the LP source and move the cylinder to a well-ventilated
area outdoors, out of the reach of children. The cylinder must not be
stored in a building, garage, or any other enclosed area.
• Ensure that there is no obstruction to air ventilation.
• Be sure all gas connections are tight and there are no leaks.
• Be sure the cylinder cover is clear of debris.
• Be sure any component removed during assembly or servicing are
replaced and fastened prior to starting.

Before Lighting

• Heater should be thoroughly inspected before each use, and by a
qualified service person at least annually.
• If relighting a hot heater, always wait at least 5 minutes.
• Inspect the hose assembly for evidence of excessive abrasion, cuts,
or wear. Suspected areas should be leak tested. If the hose leaks, it
must be replaced prior to operation. Only use the replacement hose
assembly specified by manufacturer.

Lighting

Note: This heater is equipped with a Pilot Light that allows for safer
startups and shutdowns. Pilot must be lit before Main Burner can be
started.
• Turn Cylinder Valve OFF.
• Push Control Knob IN and turn to OFF.
• Wait 5 minutes for any gas to clear.
• Turn Cylinder Valve ON.
• Open Viewing Hole by sliding cover to either side.
• Push Control Knob IN and rotate to Pilot position.
• Note - For initial start or after any cylinder change, hold Control Knob
IN for 2 minutes to purge air from gas lines before proceeding.
• Push Igniter button once. Pilot Light flame will appear and be visible
through Viewing Hole.
• Release Control Knob after 30 seconds. Pilot Light will remain lit. If
not, return to step 1.
3/28/03