Low Battery Alert; Belt Clip - Uniden UH-042XR Operating Manual

LOW BATTERY ALERT

The LCD on your radio shows a battery
meter in the lower right corner.
icon indicates a fully powered
unit. As the batteries lose power,
will flash.
When the batteries in the unit are low,
the unit will go into a Battery Low/Sleep Mode. The Scan Mode, Transmit,
Transmit Call Tone Mode are disabled. Replace the batteries immediately to
continue using the radio.

BELT CLIP

As you will usually use your radio when you are
out and about, the unit comes equipped with a
belt clip to securely fasten the unit to your belt,
pocket or purse.
To remove the belt clip, turn the screw
counterclockwise.
To attach the belt clip:
1. Insert the belt clip screw into the slot on
the belt clip.
2. Align the screw with the hole on the back
of the radio and turn it clockwise, using a
Phillips screwdriver to secure the belt
clip. Do not over-tighten.
WRIST STRAP
1. Insert the short end of the strap through
the belt clip hole.
2. Slip the long end through the loop to
enclose the clip in the strap and pull tightly.
5