KitchenAid K45 Series Manual page 6

PRODUCT ASSEMBLY
3
Place the bowl on the clamping plate
and twist to lock in place.
5
Unlock the motor head and move it
down. Then, lock the head to keep
it down. Before mixing, test lock by
attempting to raise the motor head.
(OPTIONAL) To adjust beater to bowl
clearance: Tilt and lock the motor
head back. Turn the screw slightly
counterclockwise (left) to raise the
beater, or clockwise (right) to lower it.
NOTE: If you over-adjust the screw, the
bowl lock lever may not lock into place.
*Included with select models only. Also available as an optional accessory.
6
4
Slide and rotate the accessory aligning
over the pin on the shaft.
(OPTIONAL) Place the pouring shield*:
Slide the pouring shield* from front of
the Stand Mixer over the bowl. The
bottom rim of the pouring shield* fits
inside of the bowl.
1
2