Connect Your Modem Router - TP-Link TD-W9970 User Manual

Chapter 2
2. 2.

Connect Your Modem Router

Follow the steps below to connect your modem router.
1. Connect the DSL line and power adapter. The electrical outlet shall be installed
near the device and shall be easily accessible.
1
Phone Jack
Connect the DSL splitter to the
phone jack.
DSL Splitter
2. Connect your computer to the modem router.
Method 1: Wired
Connect your computer's Ethernet port to the LAN port on the modem router via the
Ethernet cable.
Method 2: Wirelessly
Use the default SSID (Wireless Network Name) and Wireless Password printed on the
product label of the modem router to connect wirelessly.
Method 3: Use the WPS button
Wireless devices that support WPS, including Android phones, tablets, most USB
network cards, can be connected to your router through this method. (WPS is not
supported by iOS devices.)
Note:
The WPS function cannot be configured if the wireless function of the router is disabled. Also, the WPS function will be
disabled if your wireless encryption is WEP. Please make sure the wireless function is enabled and is configured with the
appropriate encryption before configuring the WPS.
Power Adapter
2
Connect the modem router
to the DSL splitter.
Connect to the phone (Optional)
Connect the Hardware
3
Connect the power adapter to the
modem router and push in to turn on
the modem router.
Modem Router
4
Verify that the hardware connection is
correct by checking these LEDs.
Power DSL Wi-Fi
On On
On
Notes:
1) The DSL LED takes about 1 to 2 minutes to
stabilize.
2) If the Wi-Fi LED is off, please press the WiFi
button on the rear panel for about 1 second, then
the LED should turn stable in a few seconds.
9