Advertisement
TOOLS NEEDED:
Power or hand held Phillips head screwdriver with #2 tip, 7/16" and 1/2" combination
wrench or thin wall sockets.
LAB TABLE FRAME ASSEMBLY FOR LAMINATE OR HARDWOOD WORKSURFACES
Step 1:
Attach beam connector plates to the ends of the bench support beams using the 5/16-18 x .75 hex head bolts
and 1/4 flat washers supplied as shown. DO NOT TIGHTEN THE
HARDWARE.
Step 2:
Place worksurface topside down on smooth flat surface being sure to protect it from damage by foreign
objects. IAC recommends the use of packing type blankets or clean cardboard. Place the support beams on
the worksurface with the open side toward the center of the worksurface and align the slots of the support
beams over the threaded inserts in the worksurface as shown. Use the 1/4-20 x .75 hex head bolts and 1/4
flat washers and thread them into the threaded inserts to attach the beams to the worksurface.
NOTE: DO NOT TIGHTEN THE HARDWARE.
4
Advertisement
