Dialling Speed Dial Numbers - Uniden FP103 Owner's Manual

NOTE
If you have selected a speed
dial button that does not have
a stored number, the
telephone will not dial and
the screen will display
]
[
EMPTY.

Dialling Speed Dial Numbers

There are two different ways to dial a stored two-touch number:
1. a. Pick up the handset and press the dial button.
b. Press the desired memory location button, either
-or-
2. a. Don't pick up the handset - press the dial button.
b. Press the desired memory location button, either
that the screen display shows the correct information.
c. Pick up handset, then press the callback button.
Chain Dialling
On certain occasions (such as telephone banking), after dialing one number, you may
wish to dial another number without hanging up. This is known as chain dialing or
cascade dialing.
Simply store the second number in another memory location. During your call, press
the dial button followed by memory location number to dial the 2nd memory. In this
way you can recall both numbers that are stored into their own memory locations at the
relevant times.
Call Timer
Approximately 10 seconds after the handset is picked up, the call counter will begin and
show the elapsed time on the display screen.
Deleting a Speed Dial Memory
1. Press the dial button and press the desired memory location number
to or or
either
0 9
2. Press the delete button - the screen displays
number.
3. Press the delete button again.
- the screen displays the speed dial contents.
#
[
DELETE
to or or
.
0 9 #
to or
or , then check
9
0 #
]
and the memory location
8