Lubrication; Replacing Agitator Brush Roll - LG V-UP851NB Owner's Manual

3-16
D
Installing new belt
With lettering on outside of belt, and
positioned as shown, slide new belt
over motor pulley (D).
3-19
Replacing bottom plate
Reposition bottom plate and 5 Phillips
head screws. Tighten screws securely.

Lubrication

The motor is equipped with bearings
that contain sufficient lubrication for
the life of the motor. The addition of
lubricant could cause damage.
Therefore, do not add lubricant to
motor bearings.
3-17
E
G

Replacing agitator brush roll

Insert agitator through belt and place
belt in belt guide (E) on agitator.
Should the agitator shield (F) become
dislodged while replacing the belt or
the agitator, reposition it as shown
noting the placement of its belt guide
(G).
The agitator brush roll
When to replace
When agitator brushes are worn, the
agitator should be replaced.
To check condition of brushes, dis-
connect cleaner from electrical
outlet.
3-20
Move edge of a card across bottom
plate while turning agitator. To maintain
cleaning effectiveness, replace agitator
if brushes do not touch card.
Thermal protector
An internal thermal protector has been
designed into your cleaner to protect it
from overheating.
When the thermal protector acti-
vates, the cleaner will stop running.
If this happens, proceed as follows:
1. Turn the cleaner OFF and dis-
connect it from the electrical out-
let.
2. Check filters for dirt accumulation.
3. Refer to "Clearing blockages"
section.
3-18
F
I
Securing agitator
Grasp agitator firmly and fit it into
position by first sliding end opposite the
belt into the rectangular slot (H) on side
of cleaner.
Pull other side of agitator (I) into place.
Turn agitator making sure belt turns
freely and is not pinched between
agitator and bottom of cleaner.
Disconnect cleaner from electrical
outlet.
Remove bottom plate, belt and agi-
tator following directions in "The belt"
section beginning with Fig 3-14.
Discard old agitator.
Continue following the directions in
"The belt" section to reposition belt,
new agitator and bottom plate.
4. When cleaner is unplugged and
the motor cools for 30 minutes,
the thermal protector automatically
resets and cleaning may continue.
If the thermal protector continues to
activate after following the above
steps, your cleaner may need
servicing.
H
9