Appendix B - Parts And Suppliers For Slcd+ Controller Connections; Connectors And Cables For; Cables For; Discrete Wire Cable Vendors - Reach Technology SLCD+ Manual

Appendix B - Parts and suppliers for SLCD+ controller
connections
B.1 Connectors and cables for J6, J10
The board connector is Molex type 53261-0890 (J6) and 53261-0490 (J10). The mating
connector is made of two parts: a receptacle housing and crimp pins. A special tool is
needed to make the crimps. Alternatively, custom cables can be purchased. See B.3 for
cable vendors.
J6, J5 Receptacle housing Molex P/N 51021-0800
J4 Receptacle housing Molex P/N 51021-0300
J10 Receptacle housing Molex P/N 51021-0400
Crimp pins Molex 50079 or 50058
Prototype (small qty) crimp tool Molex 63811-0200
Production crimp tool Molex 63811-0000
All of the above are available from www.digikey.com
B.2 Cables for J7, J9
These connectors attach to flat flex cables that then attach to the display unit. These
cables can be ordered from either
www.axoncable.com
B.3

Discrete wire cable vendors

The cables needed for any of the 1.25mm cables can be specified and supplied as
assembled cables by:
www.intcomptech.com
or
Interconnect Marketing Solutions
thuynh@interconnectmarketing.com
SLCD+ Controller Manual V1.1
or www.quadrangleproducts.com
8/14/2009
or www.digikey.com
Page 26