Selecting A Memory - Uniden UBC340CRS Owner's Manual

Bank 6
5 6
5 6
5 6
54 64
55 65
56 66
57 67
58 68
59 69
60 70
Once you fill out the above chart, follow these steps to enter or change a
frequency in a memory:
. Press E/PGM to enter the program mode (the scanner turns on the
PGM icon).
. If the current channel is not the one you want to program, enter the
memory number then press HOLD.
. Enter the frequency including the decimal point, then press E/PGM.
4. To program the next memory, press s or t and repeat step . To
program a different memory, repeat from step .
5. To exit program mode, press HOLD or SCAN or change the scanner's
mode.
Notes:
• Any frequency you program replaces the previous memory contents.
• If you enter a frequency you have already stored in a different
memory in Step , the scanner beeps and displays the channel
where you have previously stored the frequency. If you want to store
the frequency anyway, press E/PGM a second time in Step .
• To clear the contents of a memory, enter "0" in Step .
• Channels you program are automatically unlocked (see "Locking/
Unlocking Memories) and have Delay turned on (See "Setting
Channel Delay").

Selecting a Memory

To select a single memory to monitor, press HOLD. The scanner turns

UBC40CRS OM.indd 
Bank 7 Bank 8
7
7
7
74
75
76
77
78
79
80
Bank 9
8
8
8
84
85
86
87
88
89
90
Using the Scanner Memories
Bank 10
9
9
9
94
95
96
97
98
99
00
7/5/08 4:8:9 PM