Uniden Bearcat UBC 120XLT Operating Manual page 9

c.
Memory Bank
Numbers
-
Each Memory
Bank consists of 10 channels that you can
select or deselect during scanning operation,
using the numeric keypad. When you select a
Bank, its number appears on the display. When
you deselect a Bank, its number disappears
from the display. When you press
~
to stop
scanning, only the Bank of the current channel
appear~
Low Battery Indicator
- Appears on the
display when the Battery Pack is Iow and needs
recharging.
Frequency Indicator
- 7-digits plus decimal
indicate the frequency being reqeived by the
scanner.
Mode
Indicators - (Only the active mode(s)
are displayed during operation.)
DATJ(
Indicates DATA SKIP activated
during SEARCH.
SCN Indicates SCAN Mode.
SRCH Indicates SEARCH e. Flashes
when in TURB ARCH Mode.
PRI ica es PRIORITY SCAN Mode.
HOLD IndicatesSCAN.HOLD or SEARCH.
HOLD
I
D.
E.
F.
DLY
UO
Indicates DELAY is activated.
In SCAN Mode indicates the channel
shown is "locked Out".
In SEARCH Mode indicates the
frequency shown is "Locked Out".
WX Indicates WEATHER SCAN Mode.
... Indicates t hekeypad islocked.
PriorityChannelIndicator - Pappears
when the scanner stops on a Priority Channel.
2. Press
@
to start scanning all programmed channels
that are not locked out. (SCAN moves across the display
during scanning.)
3. In SCAN Mode, press
~
to stop scanning. (HOLD
appears on the display.) After you stop the scanner,
press
@
again to resume scanning.
G.
H.
7