Location; Cleaning; Repairs - Uniden Bearcat UBC 120XLT Operating Manual

==-
6. Insert the Battery
Pack by placing the
side with the label in
the case first. Make
sure it is seated
within the case before
replacing the Battery
Cover.
fOOl
@CQ.:)@
7. Replace the Battery
Cover by putting the
two tabs in the
corresponding
opening and sliding it
upward until it locks in
place.
fOG')
@C.9.J@
~
.
Location
.
If strong interference or electrical noise is received,
relocate the scanner or its antenna away from the
source of the noise. A higher elevation, if possible, may
provide better reception.
. Do not use the scanner in high-moisture environments
such as the kitchen or bathroom.
. Avoid placing the unit in direct sunlight or near heating
elements or vents.
Cleaning
. Disconnect the power to the unit before cleaning.
. Clean the outside of the scanner with a mild detergent.
. To prevent scratches, do not use abrasive cleaners or
solvents. Be careful not to rub the LCD window.
. Do not use excessive amounts of water.
Repairs
Do not attempt any repair. The scanner contains no
serviceable parts. Contact the Uniden Service Division or
take it to a qualified repair technician.
23
I