Table of Contents
Advertisement
1.4
Installation
When connecting the power cable, do not remove the in-line fuse holder. To prevent the
possibility of injury or product damage caused by fire or overheating, the appropriate
fuse must be in place as indicated in the product specifications. In addition, connecting
the power cable without the appropriate fuse in place voids the product warranty.
Failure to install and maintain the equipment in accordance with these instructions could
result in damage or injury.
Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or
sanding.
When drilling or cutting, always check what is on the opposite side of the surface.
The device should be installed by a qualified marine installer.
Read all installation instructions before proceeding with the installation. If you
experience difficulty during the installation, contact Garmin support.
1.4.1
Typical Configuration
The diagram shows a typical configuration of the device.
1.4.2
Tools Needed
• Bail mount: drill and drill bits appropriate for the surface and hardware
• Flush mount: drill and 14 mm (9/16 in), 6 mm (1/4 in) and 3.6 mm (9/64 in) drill bits
with nut plates, or 3.2 mm (1/8 in) drill bit without nut plates
12
NMEA 0183
Network
WARNING
CAUTION
NOTICE
or
Antenna
CR 1522
10–36 VDC
Power Supply
GPS Antenna
Gyro/Heading
Sensor
Rectifier
115/230 VAC
Power Supply
CHAPTER 1 INTRODUCTION
Advertisement
Table of Contents
