Using The Flash Button; Chain Dialling; Erasing A Stored Number; Replacing A Stored Number - Uniden XS610 Owner's Manual

The flash + 2 call waiting
procedure toggles between
the incoming and original
call (and visa versa).
The flash + 1 procedure
will drop the current call
connection and pick up the
incoming call on hold.
16

USING THE FLASH BUTTON

Australia
If you have the "call waiting" service and a call waiting
tone sounds while you are on a call, press
to accept the waiting call. There is a short pause,
2
then you will hear the new caller. To return to the
original caller press
flash
New Zealand
If you have the "call waiting" service and a call waiting
tone sounds while you are on a call, press the
button to toggle between the incoming call and the
original call (and visa versa).

CHAIN DIALLING

After dialling a number you may be requested to enter a special access code, for
example, when performing a banking transaction.
1. Store the access code into one of the memory locations (0-9).
2. Dial the main number.
3. Press and the memory location where you stored the access code at the
mem
appropriate time.

ERASING A STORED NUMBER

1. Remove the handset from the base.
2. Press twice.
mem
3. Press the memory location number (0-9) you want to clear. You hear a long
beep confirming that you have erased the number.

REPLACING A STORED NUMBER

Remember your XS610 phone has 10 memory locations, represented by the
numbers 0-9 on the keypad. If you store a phone number in one of these
locations, then attempt to store a different number in the same location later, the
new number will replace the previous one.
flash
then .
1
flash
then
flash
flash