Table of Contents
Advertisement
OPERATION
Set the handset's POWER ON/OFF
switch to ON. For best reception, fully
extend the base's antenna and posi-
tion it vertically.
To make a call, lift the handset and
press the handset's TALK/HANGUP
button so that the TALK/HANGUPindi-
cator lights.
To answer a call, simply lift the hand-
set from the cradle so that the
TALK/HANG UP indicator lights
To end a call, place the handset on
the cradle. Or, press the handset's
TALK/HANGUP button so that the
TALK/HANG UP indicator turns off.
Note: When you press a button ex-
cept PRIVACY,a tone sounds to indi-
cate that the phone accepted the
command.
USING PRIVACY
Use the privacy feature if you do not
want the person on the other end of
the phone line to hear you as you talk
to someone in the same room as you.
You can still hear the person on the
other end of the phone line.
Press and hold down PRIVACY. T his
turns off the handset's microphone.
Release PRIVACY to resume your
phone conversation.
USING FLASH
000
000
P1
P2
P3
~~~
REDIALJPAUSE FLASH
~~~
Use FLASH to perform the switch-
hook operation for special services,
such as call waiting.*
For example, if you have call waiting,
press FLASHto take an incoming call
without disconnecting the current call.
Press FLASH again to return to the
first call.*
Notes:
.
The redial memory does not store
the FLASH entry or the digits you
press after the FLASH entry.
.
If you do not have any special
phone services, pressing FLASH
might disconnect the current call.
*.
If this does not work and you have
telecom's easycall service con-
nected, then follow your telecom
instructions to operate "call wait-
ing".
7
Advertisement
Table of Contents
