Operating The Answering System While You Are Away From Home - Uniden WDSS 5355 Series Owner's Manual

Operating the Answering System While You Are Away from Home

You can access your answering system while you are away from home to check, play, and delete messages, or turn
your answering system on and off.
Notes:
• The answering system will only playback messages for four minutes and then it returns to the command waiting
mode. To continue playing your messages, press [#] then [2] again within fifteen seconds.
• If you enter an incorrect security code three times, you will hear a beep and the answering system will return to
standby.
To operate from a remote location, use any touch-tone telephone, and follow these steps:
1) Call your telephone number and wait for the system to answer. If the answering system is off, it will answer after
about fifteen rings and sounds a series of beeps.
2) During the greeting or the beeps (if answering system is off), press
two seconds (see Setting a Security Code or Personal Identification Number (PIN) on page 42).
3) The answering system announces the current time and the number of messages stored in memory.
You hear "To play incoming messages, press pound-two. For help, press pound-zero" followed by a beep.
4) Enter a remote command from the chart below. You have fifteen seconds to enter the first command; after the
first command, you have two seconds to enter each command.
Remote Commands
Command
[#] then [1] Repeat a message*
[#] then [2] Play incoming messages [#] then [5] Stop operation
[#] then [3] Skip a message
* If you press [#] then [1] in the first four seconds of a message, the system skips to the previous message.
If you press [#] then [1] after the first four seconds of a message, the system repeats the current message.
5) When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode.
Enter another command from the chart within fifteen seconds.
6) Hang up to exit the system. The answering system automatically returns to its normal standby setting.
Function Command
[#] then [4] Delete a message
[#] then [6] Answering system on
[#] and enter your security code/PIN within
Function
46
Command Function
[#] then [9] Answering system off
[#] then [0] Help