Advertisement
Quick Links
Drivers Side
* FB23083 (4DR) shown
REQUIRED TOOLS
16mm socket
18mm socket
OPTIONAL TOOLS
7/16" drill bit
Paint pen
Centerpunch
1)
REMOVE FACTORY STEPS OR GUARDS
If equipped, remove the factory steps or rocker
guards.
2)
REMOVE HARDWARE
On the passenger side, remove the crossbar bolt
using an 18mm socket.
Step sliders - 4DR
Passenger Side
KIT CONTAINS
Step slider (L and R)
*Nut plate
*M10 bolt
*M10 flat washer
*M10 lock washer
* - Optional hardware
FB23083 & FB23084
Jeep® JL Wrangler
(FB23083)
On a 2DR model, it may be required to loosen the
skid plate bolt to allow enough flex to fit the new
step slider between the frame and crossbar.
Remove the nuts from the rear-most body mount
using a 16mm socket. For 4DR models, repeat this
step on the middle body mount.
and 2DR
(FB23084)
QTY
1 ea
2
2
2
2
2308300
Advertisement
Related Manuals for Fishbone Offroad FB23083
Summary of Contents for Fishbone Offroad FB23083
- Page 1 FB23083 & FB23084 Jeep® JL Wrangler Drivers Side Step sliders - 4DR and 2DR (FB23083) (FB23084) Passenger Side * FB23083 (4DR) shown REQUIRED TOOLS KIT CONTAINS 16mm socket Step slider (L and R) 1 ea 18mm socket *Nut plate *M10 bolt...
- Page 2 FB23083 & FB23084 Jeep® JL Wrangler Step sliders - 4DR and 2DR (FB23083) (FB23084) NOTE: If you choose to install the optional hardware, proceed to step 5) prior to fully installing all hardware. Tighten a few nuts to hold the slider in place while marking the hole location.
- Page 3 REPEAT ON DRIVER SIDE Repeat installation process on the driver side. NOTE: The skid plate on the driver side will not need to be loosened and will not require drilling for the optional hardware. ENJOY YOUR NEW FISHBONE OFFROAD STEP SLIDERS! 2308300...
Need help?
Do you have a question about the FB23083 and is the answer not in the manual?
Questions and answers