1. Manuals
  2. Brands
  3. Careline 24 Manuals
  4. Security System
  5. CL24
  6. User's installation manual

Careline 24 CL24 User's Installation Manual

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Careline Alarm
User Installation Guide

Advertisement

Table of Contents
loading

Summary of Contents for Careline 24 CL24

  • Page 1 Careline Alarm User Installation Guide...

  • Page 2: Unpacking The Reach At-Home Alarm

    1.1 IMPORTANT INFORMATION The user’s telephone MUST BE connected to the Reach socket - a double adapter on the incoming line must not be used. If the user has a DECT telephone the base station MUST BE at least 2 metres away from the Reach. Failure to provide this separation may result in reduced range of personal pendants or other radio devices.
  • Page 3 1.3 THE TOUCH PERSONAL PENDANT The Touch pendant can be used to make an emergency call from anywhere in or around the home. The Touch pendant is waterproof but it should not be fully submerged for long periods. The Touch pendant is a life saving device; remember to advise the user to wear it at all times and keep it by their bed at night.

  • Page 4: Connecting The Reach At-Home Alarm

    1.4 CONNECTING THE REACH AT-HOME ALARM Basic Connections... The Reach will usually be table mounted within 3 metres of a mains supply and the master telephone socket. If extension cables are used care should be taken to ensure that no one trips over the leads.
  • Page 5 1.5 REACH AND BROADBAND Broadband Service Providers will supply a filter module to plug into the telephone line to allow connection of a computer and a normal telephone. Only one filter module is required to connect the computer, telephone and Reach when configured as shown below: MASTER TELEPHONE SOCKET...

  • Page 6: Switching The Reach At-Home Alarm On

    1.6 SWITCHING THE REACH AT-HOME ALARM ON Connect the power lead and switch the mains supply on, the front light will flash AMBER GREEN for about 12 seconds... 1.7 SWITCHING THE REACH AT-HOME ALARM OFF The Reach At-Home Alarm uses very little power and should always be left switched ON. If it necessary to switch the unit OFF, follow the procedure below: 1.

  • Page 7: Making An Emergency Call

    1.8 MAKING AN EMERGENCY CALL An emergency call can be made at any time of the day or night. 1. Press the RED ((•)) button on the Reach unit or press the Touch pendant... 2. The Reach will start to make an emergency call... The front light will go STEADY RED and the...

  • Page 8: Monthly Checks

    1.9 MONTHLY CHECKS To ensure your equipment is functioning correctly we highly recommend that you perform a test call every month. Please press your pendant to activate a call and allow the unit to connect to our care team. When they answer just inform our operator that you are performing a test call. They will confirm everything is working correctly and they will then close down the call.

Table of Contents