Installation - Nectre Fireplaces N550 Installation Instructions Manual

Installation

Before Installation
After unpacking, check that the
following parts are included inside
the wood-fired oven.
• 2 side baffles
• Handle for air control
• Lifter for cook plates
• Allen key for adjustment
of top air discharge
Assembling your Nectre
Wood-Fired Oven
The Nectre N550 Wood-Fired Oven
comes mostly assembled, however
some parts may need adjusting /
to be added before firing the stove.
It is important that the following
components are used ensure
compliance.
Installing the by-pass
damper
1. Before installing the flue, the
by-pass damper handle must
be fitted. The handle is supplied
inside the firebox. Insert the
threaded end of the handle into
the 10 mm (0.40") hole on left
side of the oven.
Looking down through the flue
spigot locate the threaded end of
the handle with the extended nut
attached to the by-pass damper.
Screw the handle all the way into
the nut until tight.
6
2. The position of the handle should
be at approximately 11 o'clock
when the damper is open, and
1 o'clock when the damper is
closed.
!
NOTE: Do not alter the damper
adjustment range to increase firing
for any reason.
Installing fire bricks
The oven comes with 4 fire bricks
9" x 4½" x 1½" (230 mm x 115
mm x 38 mm), a 19" (480 mm)
long brick retainer as well as two
triangular bricks 2" x 2 ¾" x 10"
(50 mm x 70 mm x 250 mm) for the
front. Refer to Figure 1.
Place the four fire bricks upright, up
against the rear wall of the firebox.
Place the U-shaped brick retainer
over the top of the bricks such that
the bricks fit inside the U-section.
This will hold them in place. Place
the triangular firebricks at the front
of the firebox beneath the door
opening.
Figure 1
Firebox side
shield
Triangular
firebrick
www.nectre.com/usa-nectre
Brick retainer
Rear
firebrick