Nectre Fireplaces N550 Installation Instructions Manual page 7

Installation
!
NOTE:
The firebricks may
already be in place upon arrival of
your wood-fired oven.
!
NOTE:
The triangular fire bricks
are siliconed in place for transit. After
initial use the silicon will break down
and they bricks can be removed.
Remove the side baffles by lifting
upand away from the wall prior to
removing triangular bricks
Installing baffle plate
1. The oven comes with a 10" x
12 ¾" x 6" (250 mm(d) x 325
mm(w) x 150 mm(h) mm) baffle
plate. This rests on the two lugs
welded to the inside front of the
firebox and on the brick retainer at
the back of the oven.
2. Position the baffle plate vertically
towards the rear of the firebox
with the 4" (100 mm) strip welded
to the baffle at the top facing
forward. Bring the top edge
towards the front of the oven so
that it slides up and over the two
support lugs with the 4" (100 mm)
strip located between them. Raise
the lower rear edge of the baffle
plate to rest on top of the brick
retainer.
3. With the baffle plate in its correct
position, ensure it is pushed all
the way back so that it doesn't fall.
Installing top air control rod
A stainless-steel rod with a thread at
one end and black knob on the other
will have been supplied in the oven.
Pass the threaded end of the rod
through the hole near the top front
corner on the left side of the oven.
Push the rod through until one can
feel it has located the nut on the air
slide, then screw rod until tight. Refer
to figure 2. Check that the rod slides
freely back and forth.
Figure 2
Top air control rod installation
7