Related Manuals for 3M 4488
Summary of Contents for 3M 4488
- Page 1 4488 and 4588 Protected Entrance Terminals Instructions Underwriters Laboratories (UL) Listed July 1996 78-8113-4488-2...
-
Page 2: Table Of Contents
11.0 Protective Cover Installation ......................... 6 1.0 General The 3M brand Protected Entrance Terminals (PETs) provide protection and termination of entrance and distribution cables, are available in 25, 50 and 100 pair count and are Underwriters Laboratories (UL) Listed. 4588-25... -
Page 3: Accessories
4.0 Tool Requirements 1.02 Terminal Wiring Schematics: Protector The following tools are required to install the 3M brand PETs: Module Typical Entrance Cable Modular - Standard Hand Tools Hardwire - MS Modular Splicing Rig Block From C.O. - MS 4044 Splice Head Frame Adapter... -
Page 4: Entrance Cable Preparation And Termination
7.09 Bond entrance cable shield to insulated ground wire per standard procedure. 7.03 For top entry, slide 3M brand Pull'N'Shrink 7.10 Slide the plastic gland toward the cable entry port, Tubing (PST) over cable sheath with pull tab align the groove and insert into the cable port. -
Page 5: Multiple Terminal Installation
7.13 After positioning PST as close as possible to h. Place extension stub into splicing head. Place terminal side, continue core removal to collapse short stub with corresponding binder group on PST over clamp halves. Complete core removal. top. Use green base retainer posts for alignment. -
Page 6: Distribution Cable Termination
822365 843017 9.0 Distribution Cable Termination f. Install second clamp half over binder groups 9.01 4488 Protected Entrance Terminals by snapping together. Terminate station wire or 22-26 AWG jumper wire onto Modular Hardwire Block with screwdriver. a. Split pair (Tip-left, Ring-right) at the assigned binding post. - Page 7 Push pair probe forward until the clamps snap 842982 behind the cap heads. 2" (51 mm) Slack Loop 9.03 Testing 4488 Terminals Note: Binding post screw heads have been coated with a nonconductive material resulting in a "Quiet Front" condition. Use 842989 only approved test equipment on block.
-
Page 8: 10.0 Protector Installation And Testing
SUSTAINED OR INCURRED BY REASON OF THE USE OF ANY OF THE SELLER'S PRODUCTS THAT WERE DEFECTIVE. Telecom Systems Division 6801 River Place Blvd. Recycled paper Litho in USA Austin, TX 78726-9000 40% pre-consumer © 3M 1996 78-8113-4488-2 800/426-8688 10% post-consumer...