Attaching, Detaching And Storage; Maintenance Safety; Prepare For Emergencies - Landoll 7822 Series Operator's Manual

• Avoid sudden stops or turns because the weight of
the implement may cause the operator to lose control
of the tractor.
• Use caution when towing behind articulated steering
tractors; fast or sharp turns may cause the implement
to shift sideways.
• Keep clear of overhead power lines and other
obstructions when transporting. Know the transport
height and width of your implement.
Attaching, Detaching and
Storage

DANGER
• Do not stand between the tractor and
implement when attaching or detaching
implement unless both are not moving.
• Chock the tires of the implement so it will
not roll when unhitched from the tractor.
• Store in an area where children do not play.
IMPORTANT
Never store the HSL with it's weight on the disc
blades.
Attaching the HSL to the Tractor
1. Line the tractor up with the and back up close
enough to attach the hydraulic couplers, but not too
close to interfere with the hitch.
2. Connect the hydraulic jack couplers (the 1/4" hose
lines) to the tractor so the hitch height can be
adjusted.
• This circuit will be the lowest priority circuit of all.
Pressure
(from tractor)
Front Gauge Wheels
Rear Gauge
Wing Fold
Machine Tilt
Figure 1-1: Hose Identification
TABLE OF CONTENTS
3. With the hitch height adjusted, continue to back the
IMPORTANT
Please consult your dealer if the hitch point is
forward of the rear extremity of your tracks.
4. Finish connecting the hydraulic couplers:
5. Connect the safety warning lights.
6. Raise the hydraulic jack.
7. Unhook the HSL by reversing the procedure called

Maintenance Safety

•
•
•
•
Return

Prepare for Emergencies

(from machine)
•
•
INTRODUCTION & SAFETY
tractor up and drop the hitch pin in.
• For "wheeled" tractors, it is standard for the hitch
pin to be 1 inch behind the rear extremity of the
rear tractor tires.
• "Track" tractors can vary from this standard and it
may be desirable to have your hitch extended.
• Highest priority, and most accessible control,
"Red" circuit, machine tilt circuit.
• Second priority, "Blue" circuit, front gauge wheels
and depth control.
• Third priority, "Black" circuit, rear reel control.
• Fourth priority, "Yellow" circuit, wing fold circuit.
out above.

DANGER
Do not make adjustments or lubricate
implement while it is in motion.
Understand the procedure before doing the work.
Use proper tools and equipment.
Make sure all moving parts have stopped.
Block the implement so it will not roll when working
on or under it to prevent injury.
Keep a first aid kit and fire extinguisher handy.
Keep emergency numbers for doctor, ambulance,
hospital, and fire department near the phone.
1-3