Table Of Contents; Introduction - Swann Smith's Caspian EC Series Installation And User Manual
Fan convectors
Hide thumbs
Also See for Smith's Caspian EC Series:
- Installation, commissioning and user manual (24 pages)
Table of Contents
Advertisement
Contents
2 | SmithsEP.co.uk | Issue 001 - July 2020
Introduction
2
Suitable for Caspian (UV, FF, EXT, SL, TT)
3
These heaters must not be installed in wet rooms
3
or other high humidity areas.
4
These heaters are designed for use on standard
6
two-pipe pumped central heating systems with
a maximum water temperature of 86°C and a
6
maximum pressure of 6 bar (88lbs/in.).
7
Pipe connections are 22mm and either pipe may
9
be used as flow or return.
10
These heaters are classified as a fixed appliance
11
and the electrical connection should be via a 3A
13
fused spur. The fused spur must not be directly
13
below the heater but should be accessible after
completion of the installation. All heaters must be
13
earthed.
14
It is recommended that this heater is wired via a
14
remote room thermostat.
14
To avoid the possibility of vibration these units
15
must be fitted to a flat even surface.
15
This heater is fitted with a 35°C Low Temperature
15
Cut-out (LTC). An adjustable low temperature
cut-out is also available (see page 10).
To conform to Building Regulations Part L (Part J
in Scotland), a remote room thermostat can be
used in conjunction with this heater. Refer to the
instructions supplied with the thermostat.
Please note the guarantee may be invalidated
if this product is not installed and used in
accordance with these instructions.
Advertisement
Table of Contents
