Install Bracket - Cisco 6901 Manual

Cisco Unified IP Phone Wall Mount

Install Bracket

Install Bracket
To install the phone on the wall, perform these steps:
Procedure
Step 1 Mount the wall bracket in the desired location. You can install the wall bracket over an Ethernet jack, or you
can run the Ethernet network cable to a jack nearby.
a) Use the level to ensure the wall bracket is level, then use a pencil to mark the screw holes.
b) Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor
into the wall to make markings on the wall.
c) Screw the anchor clockwise into the wall until it is seated flush.
d) Use the included screws and a #2 Phillips-head screwdriver to attach the wall bracket to the wall.
Cisco Unified IP Phone Wall Mount
5