Changing From Tone To Pulse Dialing; Resetting And Registering Handsets - Uniden DECT2180 Series User Manual

Dect2180 series
Hide thumbs Also See for DECT2180 Series:
Table of Contents

Advertisement

this problem. The technician who installed your DSL service might
have left some filters for you; if not, call your DSL provider or look in
any electronics store.
Plug the DSL filter into the telephone wall jack and plug your phone's
base into the filter. Make a test call to make sure the noise is gone.

Changing from Tone to Pulse Dialing

Your phone can communicate with the telephone network in two
different ways: tone dialing or pulse dialing. These days, most
telephone companies use tone dialing. If your phone company uses
pulse dialing, you will need to change your phone's dial mode.
1)
From a handset, open the menu & select Global Setup.
2)
Select Dial Mode, then select Pulse. The phone sounds a
confirmation tone.
If you use pulse dialing and you need to send DTMF tones during a
call (if you're using an automated response system, for example),
press
to temporarily switch to tone dialing. When the call ends, the
phone automatically returns to pulse dialing mode.

resetting and registering Handsets

If you are having trouble with a handset or if you want to replace one,
you need to clear the registration information from the base and the
handset:
Do you have the base the handset is registered to?
1.
Press & hold
Reset menu appears (about 5 seconds).
2.
Select Deregister HS. The display lists
all registered handsets.
3.
Select the handset you want to reset.
4.
When the phone asks you to confirm,
select Yes. The handset clears its
information from the base & deletes it
own link to the base.
When you reset a handset (or if you buy a new one), that handset
displays a Handset Not Registered message. If you see this message
on a handset, you need to register it to a base before you can use it.
Yes
and
until the System
END
#
No
1.
Press & hold
the System Reset menu
appears (about 5 seconds).
2.
Select Base Unavailable.
3.
When the phone asks you
to confirm, select Yes. The
handset deletes its own link
without contacting the base.
and
until
END
#


Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents