Table of Contents
Advertisement
[#18-1]
Control Lever/
P
/
B
Throttle Lever/
P
/
B
Throttle Trigger/
/
[WX21]
Do not pull the Starter rope all the way out . It may damage the machine.
Do not disassemble the Starter. Please ask for an authorized Unisaw service dealer.
After the engine is started turn the choke lever to the Open "
[WX24, WX30, WX42]
Then squeeze and release the throttle trigger to allow it to return to the idle position.
If the engine stops running before you turn the choke lever to "
[WX21]
Go ahead and open the choke, pull the starter grip.
[WX24, WX30, WX42]
Go ahead and open the choke, pull the starter grip with the throttle trigger positioned at
Fast-idle start position.
.
Unisaw.
"
".
[WX24, WX30, WX42]
.
"
".
[WX21]
[WX24, WX30, WX42]
.
.
"
".
[WX24, WX30, WX42]
.
,
"
".
[WX21]
[WX24, WX30, WX42]
,
.
[#18-2]
Stop switch/
/
[WX21]
CAUTION
WARNING
" position.
" position.
.
.
-
.
Unisaw.
,
.
[#18-3]
Fast-idle start lock/
START(ON)
STOP(OFF)
Stop switch interruptor "Stop"
"Stop"
"Stop"
[WX24, WX30, WX42]
HOT RESTART
To start the engine that is already warmed up (hot restart).
1. Pump the primer bulb until fuel can be seen flowing through the fuel return line to the
fuel tank. Flowing fuel should be almost clear, not foamy or full of bubbles.
2. Turn the choke lever to the open "
position.
3. Leave the throttle trigger in the idle position and pull the starter grip. [#18-1]
4. If the engine fails to start after three to four pulls, follow the instructions in the Cold
Starting Procedure section above.
If the engine fails to start after you follow
Unisaw dealer.
TO STOP THE ENGINE
[WX21] [#18-2]
1. Release the throttle lever.
2. Push the stop switch of the throttle trigger until the engine will stop.
[WX24, WX30, WX42] [#18-3]
1. Release the throttle trigger.
2. Slide the stop switch to "STOP" position.
1.
.
2.
«ON» (
3.
. [#18-1]
4.
«
[WX21] [#18-2]
1.
.
2.
.
[WX24, WX30, WX42] [#18-3]
1.
2.
,
.
1.
.
,
2.
«ON».
3.
. [#18-1]
4.
«
If the engine fails to start after you follow the above procedures, contact an authorized
Unisaw dealer.
[WX21] [#18-2]
1.
b
2.
[WX24, WX30, WX42] [#18-3]
1.
2.
- 18 -
/
Fast-idle start position
Pozi ie mers în gol
Pozycja biegu ja owego
" position, and set the stop switch to the "ON"
the above procedures, contact an authorized
(
).
,
.
"
.).
-
,
»
.
,
.
«STOP» (
).
(
),
,
,
,
.
«
-
,
».
.
,
.
«STOP» (
).
,
",
»
.
Advertisement
Table of Contents
