7
Mec 2230sW
-1
REplACING AIR fIlTER (h)
(1) filter
(2) cap
(3) evacuator valve
1. park the vehicle on level ground
and apply the parking brake firmly.
2. stop the engine and raise the car-
go bed.
3. Open the cover of the air filter can-
ister to replace the filter.
4. Make sure to fit the filter to the
center of the canister.
5. install the canister cover after
checking that the anti-dust valve is
facing downward without any gap.
UD130(MEC2230SW)-유럽향-07.indd 14
ChECkING AIR hosE AND ClAMp(I)
if there is a tiny gap caused by a
loose connecting clamp on the air
hose, air without passing through the
air filter could enter the system for a
long period of time, resulting in short-
ening the service life of the engine.
carry out the check according to the
service intervals in this manual as
follows.
UUVo713A
(1) clamp 1
(2) clamp 2
1. park the vehicle on level ground
and apply the parking brake firmly.
2. stop the engine, remove the seat
cushion and raise the cargo bed.
(in case the hydraulic dumping kit
is installed, raise the car go bed
before stopping the engine.)
3. check if the clamps (1 and 2) are
loose. if so, tighten them.
4. check if there is tiny cracks or
flaws on the rubber hose and re-
place it if necessary.
UUVo714A
2015-10-28 오후 12:01:47
Need help?
Do you have a question about the MEC 2230SW and is the answer not in the manual?