Handsfree Mode; End A Call; Receive A Call; Call Waiting - Uniden DECT1725 Series Owner's Manual

Handsfree mode

You can use handsfree mode to talk to your caller
without holding the handset to your ear. You can
speak into the handset microphone and listen over
the loudspeaker.
Handsfree also enables other people in the room to
listen in to the conversation.
During a call:
1 Press . The symbol is displayed while
speaker/p
in handsfree mode.
2 Press again to go back to the normal talk
speaker/p
mode.

End a call

1 Press .
Or
Place the handset back on the base/charger.

Receive a call

When you receive a call the handset(s) will
ring (as long as handset ring volume is not set to
OFF - see page 20).
The symbol will flash in the handset display.
If you have subscribed to a Caller ID service
through your network supplier, the caller's number
will be displayed (if available). See page 32 for
further information on Caller ID.
1 Press to answer the call.
Or simply lift the handset from the base (providing
Auto Answer is set to On, see page 21). After a
short delay the call timer will start timing the call.

Call Waiting

If you subscribe to Call Waiting and the call waiting
tone sounds during a call:
Australia: Press then 2 to switch between
rdl/f
callers.
New Zealand: Press to switch between
rdl/f
callers.

Receiving internal calls

If you receive a call from another handset, the
symbol and the internal caller's handset number
will be displayed.
[13]