Advertisement
4. OPERATION
4.1
This LED floodlight develops minimal heat and is not subject to the same restrictions that apply to halogen lamps that become too
hot to touch. We do however recommend that the floodlight should not be placed in cramped or restrictive situations and recommend
the following minimum distances between the light and any surface/object.
● 500mm minimum between the top of the light and any overhead surface, or objects.
● 200mm between sides of light any surface
● 1 metre minimum between the front of the light and any object to be illuminated.
4.2.
Press the on / off button (fig.1.3) to switch light on to 50% of illumination press button again for full illumination, press again to switch
off (LEDE085 only). LED084 has simple on/off switch (fig.1.2).
4.3.
The number of green charge indicator lights (fig.1.6) showing denote the level of charge.
4.4.
The battery can be recharged at any time. To recharge: insert the charger jack into the charger socket (fig.1.4). Connect the charger to
the electrical supply and switch on. Ensure that the light is switched off during charging.
4.5.
The battery may be charged separately from the floodlight if required.
4.6.
When all the charge indicator lights are lit, charging is complete. Switch off the charger and remove from charging socket.
4.5.
To remove the battery press the two release clips (fig.1.1) and slide the battery from the floodlight housing.
4.6.
LED085 includes a 5v 1A USB socket (fig1.5), which may be used to charge or power small electronic devices
4.7.
Extra batteries can be bought as a spare part (LED084B, LED085B)
WARNING! Ensure the light is disconnected from the mains power supply when not in use. Ensure that the unit is cool and dry and
is stored in a cool, dry, childproof area.
© Jack Sealey Limited
fig.1
Original Language Version
Key to fig.1:
1: Battery release clips
2 On/off switch
3: Low/high/off switch
4: Charger socket
5: USB socket
6: Charge indicator lights
LED084, LED085
Issue:2(I) - 02/03/17
Advertisement
