Download Print this page
Sealey LED057 Instruction Manual

Sealey LED057 Instruction Manual

W cob led rechargeable floodlight lithium-ion cri95

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Instruction Manual
1. SAFETY
1.1.
GENERAL
Ensure the floodlight is correctly charged before initial use.
DO NOT cover or block the lens during use.
DO NOT turn the floodlight on when it is being re-charged.
DO NOT shine directly into your, other person's or animal's eyes.
DO NOT allow children to use the floodlight.
DO NOT use the floodlight if you suspect that the battery or the spotlight casing is damaged.
DO NOT immerse the floodlight in water.
Be aware that the lamp housing will get hot during use.
Ensure replacement batteries are genuine Sealey batteries of the same rating.
Ensure the floodlight is unplugged and allowed to cool before attempting any cleaning or replacement.
When not in use store the floodlight in a safe, dry, childproof location.
1.2.
BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
DO NOT attempt to open, disassemble, modify or service the battery.
Ensure the charger is switched off and disconnected from the floodlight before attempting to open the lamp unit.
DO NOT expose to temperatures above 60°C (140°F).
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
Replace only with the battery designated for this product.
Dispose of the old batteries in accordance with local authority battery regulations. DO NOT dispose of with regular refuse.
If the electrolyte in the cells contacts the skin, wash thoroughly with soap and water.
If the electrolyte in the cells gets into the eyes, rinse thoroughly with cool water and seek immediate medical attention.
1.3.
ELECTRICAL SAFETY
USE ONLY THE SUPPLIED MAINS CHARGER PLUG FOR CONNECTING FLOODLIGHT TO THE MAINS POWER
SUPPLY. ONLY USE THE SUPPLIED ADAPTOR FOR CONNECTING TO A VEHICLE 12V ACCESSORY SOCKET.
WARNING! It is the user's responsibility to read, understand and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices. An RCCB (Residual
Current Circuit Breaker) should be incorporated in the main distribution board. We also recommend that an RCD (Residual
Current Device) is used with all electrical products, particularly portable equipment which is plugged into an electrical
supply not protected by an RCCB.
You must also read and understand the following instructions concerning electrical safety.
1.3.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by
a qualified electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.3.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the
appliance and the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified
electrician.
1.3.3. You must ensure that you:
Inspect the charger plug, cable and connector for wear and damage to ensure items are safe before connecting to the
mains power supply. If worn or damaged DO NOT use.
Check cables are always protected against short circuit and overload.
Important: Check that the voltage marked on the charger plug is the same as the power supply to be used.
Uncoil the cable between charger and the floodlight.
DO NOT pull the charger plug from the mains socket by the lead.
DO NOT use any other type of charger with this product.
DO NOT place the connector into any area of the floodlight except the correct jack inlet socket.
DO NOT try to take the charger plug apart.
DO NOT use the charger plug to charge or power any other electrical item.
DO NOT get the charger wet, or use in wet, damp conditions (for indoor use only).
WARNING! NEVER substitute a standard 13Amp 3 pin plug, or any other type of plug, for the charger plug.
© Jack Sealey Limited
INSTRUCTIONS FOR:
20W COB LED RECHARGEABLE
FLOODLIGHT LITHIUM-ION CRI95
LED057
MODEL No:
,
Original Language Version
LED057
Issue: 1 - 03/09/15

Advertisement

loading

Summary of Contents for Sealey LED057

  • Page 1 LED057 MODEL No: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions and maintained properly, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 CRI Rating: ........95 Model No: ......LED057 Operating Time: .
  • Page 3 Undo the four hex screws on back of lamp body (fig.3) and remove the cover. Disconnect the battery plug (fig.4) and remove the batteries for appropriate disposal. Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme.