Using The Htrm 2 Remote Control; Controlling The M33; Learning Codes From Other Remotes - NAD M33 Owner's Manual

Bluos streaming dac amplifier

Hide thumbs Also See for M33:

Quick setup manual (2 pages)

Quick setup manual (8 pages)

User manual

Table Of Contents

Table of Contents

The NAD HTRM 2 is ready to operate the M33 right out of the box, but it is really eight remotes in one.

Each of the 8 Device Selector keys at the top of the handset can call up a new "page" of remote control

codes to be transmitted by the remaining keys. You may "teach" codes from any infrared-remote

controlled component, regardless of brand, to any or all of these.

Obviously, the most logical system is that you teach the codes from your BD player to the [BD] Device

Selector "page, " your television's codes to the [TV] "page, " and so on, but there is no required scheme:

You may load any commands to any key on any page (see "Learning Codes From Other Remotes, "

below).

The HTRM 2 is already preprogrammed with a full complement of commands for the M33 on its

[AMP] Device Selector page, and as well as with library commands to operate most NAD-brand CD,

BD or DAC components on the corresponding Device Selector "pages. " These default commands are

permanent: Even if you teach the HTRM 2 new commands to take their place, the underlying library

commands remain in place and can easily be recalled should you add an NAD component to your

system later (see "Delete Mode", below).

Note: For use with the M33, it should not be necessary to re-program any keys on the HTRM 2 [AMP]

page. However, in order for the HTRM 2 to control your specific NAD-brand components you may

need to load one or more different code-libraries (see "Loading Code Libraries, " below).

CONTROLLING THE M33

The HTRM 2 is divided into two main sections. Eight Device Selector keys at the top—[AMP], [MP,]

[TV,] and so on—set the handset's remaining keys to a "page" of commands to control a particular

component. A Device Select key determines only what component the HTRM 2 will command; it

does not perform any function on the M33. All of the remaining keys are function keys that can "learn"

control codes from virtually any infrared remote controller, allowing you to teach the codes of your

equipment, regardless of brand, to the HTRM 2.

However, the HTRM 2 is already preprogrammed to operate the M33. All of the function keys on the

[AMP] Device Selector "page" perform M33 functions. (The HTRM 2 can also command many other

NAD components, from its [CD], [BD], [DAC] and [CUSTOM] pages.)

It is important to note that certain HTRM 2 keys perform different functions depending on the selected

Device Selector "page. "

LEARNING CODES FROM OTHER REMOTES

Begin by positioning the HTRM 2 "nose-to-nose" with the source remote so the two devices' infrared

windows are about 2 inches apart.

1 Enter Learning Mode: On the HTRM 2, simultaneously press-and-hold for 3 seconds both a Device

Selector key and the [RES] key until the Learn LED (located between HTRM 2's ON and OFF buttons)

turns steady green.

2 Press the HTRM 2's function key you wish to teach a command; the Learn LED will turn amber.

3 Press-and-hold the function key on the source remote: The HTRM 2's Learn LED will flicker amber

for a second or two, then turn solid green. The command is learned.

Press the HTRM 2's Device Selector key again to exit the learning mode.

OPERATION