5. Menu Calibrate
Calibrate
Output
Click on
and hold for 3 second to login to calibration mode
Bias Revise Offset value on Y Axis, Shift graph up and down
Span Set up Max scale of Input/Output
Zero Set up min scale of Input/Output
Calibrate of Input
Input
Click on
and Click
Calibrate Zero turns on the minimum power. Minimum input will
show on display and setup by click
then click Exit for save and go to the next step
Calibrate Span turns on the maximum power. Display will show the
maximum input then adjust by click
and go to the next step
Calibrate Bias is for set offset value for all input. Turn on the power
and click
and go to the next step.
Page 12 of 13
บริ ษ ั ท วิ ศ ณุ แ ละสุ ภ ั ค จ ากั ด 102/111-112 หมู ่ บ ้ า นสิ น พั ฒ นาธานี ถนนเทศบาลสงเคราะห์ แขวงลาดยาว เขตจตุ จ ั ก ร กรุ ง เทพฯ 10900
โทร. (02)591-1916, (02)954-3280-1, แฟกซ์ (02)580-4427
Input
Zero
Mode
Zero
Mode
Zero
and hold for 3 second to login to calibration mode then choose
to adjust offset value then click Exit value to save
WISCO DP70 Manual V2.0
Span
Mode
Mode
Exit
Exit
Span
Mode
Exit
Exit
Span
Mode
Mode
Exit
Exit
until get desire value an
www.wisco.co.th,
,
Bias
Mode
Exit
Bias
then click Exit for save
อี เ มล์
info@wisco.co.th