Installation Steps - Progetto EVO EV105 Installation Instructions & User Manual

Installation Steps

Installation tools
Cross screwdriver
Installation precautions
1. Recommended Water pressure range: 0.1-0.75MPa.
2. Water inlet valves must be located close to the location where this
product is installed and disassembled.
Installation Procedure
Screw
Adjustment sheet
Fixing plate
Expansion bolt
Screw
Adjustment sheet
Fixing plate
Nut
Adjustable wrench
1.Remove the old toilet seat plate.
2.Place the installation template on top
of the toilet as shown. Align it with the
rim of toilet.
3A. Install fixing plate (up locking)
(1) Insert the expansion bolts into the holes on
the toilet, and place the fixing plate in the
notch part of installation template.
(2)Place the stainless steel adjusting sheets
in the mounting groove, align the expansion
bolts and tighten the screws.
3B. Install fixing plate (down locking)
(1)Place the fixing plate in the notch part of
mounting template.
(2)Place the stainless steel adjusting sheet
in the mounting groove, align the holes on the
toilet and place in the screw. Screw on the
plastic nuts from the underside of the toilet.
Note: You can choose installation method 3A or
3B depending on the actual situation.
Bucket and rag
10