Input Settings - Yamaha MTX Series Setup Manual

 INPUT settings
Make the following input settings.
CH1 Signal from the main mic of System A, connected to the EXi8
9 Signal from the main mic of System B
CH
10
CH System B signal other than the main mic
STIN1 L/R Signal from the CD player connected to ST IN1
STIN 2 L/R Signal from the background music player connected to ST IN2
STIN 3 L/R SD player built into the MTX5-D
Port select button
Port / External
Device parameter
access button
[ON] button
Fader
Channel name
Port select button
When you click this, the "Input Patch" dialog box will open. This example
makes the following changes to the default settings.
CH1 YDIF [1] (System A main mic connected to the EXi8)
CH 9 DANTE [9] (Signal from the system B main mic)
10 DANTE [10] (System B signal other than the main mic)
CH
Port / External Device parameter
access button
This lets you make input connector settings
for the MTX and EXi8. When you click the
button, a popup window will appear. Make
the desired settings, and then in the upper
right, click × to close the popup window.
The appropriate gain level will depend on
the devices that are connected, so set the
level appropriately for your devices.
For CH1, make settings for input connector
1 of the EXi8. The gain of the EXi8 is set to
-6 dB by default.
Because condenser microphone is connected to CH1, leave the gain at 30 dB and
turn phantom power on.
[ON] button
This turns the channel on/off. You should turn off unused channels.
Fader
This adjusts the input level. Leave the fader at -∞ until the system goes online.
Channel name
You can double-click this to edit the name.
In this example, names have been assigned as follows.
CH1 Main Mic
9
CH Sys B9
CH 10 Sys B10
STIN1 CD Player
STIN2 BGM
STIN3 SD Player
Example 4) A system using Dante
MTX Setup Manual
99