Store The Preset - Yamaha MTX Series Setup Manual

Verifying that the settings were applied
The main items to verify are listed below. For details on each parameter setting, refer to "MTX-MRX Editor User Guide."
Perform these checks for each MTX/MRX System.
1.
Using the oscillator in the "ROUTER" screen, adjust the output level.
Adjust the amp's attenuator value to an appropriate level.
The attenuator values of the XMV can be adjusted in the popup that is accessed by the port/external device parameter
recall button located in the output channel area of the "MAIN" screen.
2.
Specify the gain from the microphone.
You can set the gain in the dialog box that appears when you press the parameter recall button for a port or external
device of an input channel in the "MAIN" screen. Watch the input meter, and adjust the setting appropriately.
3.
Set the input levels and output levels.
Using the input/output faders in the "MAIN" screen, adjust the levels. As necessary, apply the output limiter in the
"CHANNEL EDIT" screen to prevent your speakers from being damaged.
Adjust the amp attenuator values to obtain the optimal S/N ratio.
In addition, make FBS settings as necessary.
4.

Store the preset.

When you have finished making all settings, save the project and switch MTX-MRX Editor offline.
This completes the settings for example 4.
Example 4) A system using Dante
MTX Setup Manual
123