Maintenance; Troubleshooting - Bindicator Pulse Point II Series Installation & Operation Manual

VII. MAINTENANCE
WARNING: TO AVOID IGNITION HAZARD DUE TO ELECTROSTATIC DISCHARGE, CLEAN ONLY WITH A DAMP
CLOTH.
WARNING: IN ORDER TO MAINTAIN SAFE OPERATION IN HAZARDOUS LOCATIONS, THE INTEGRITY OF
THE ALUMINUM CASTING AND THE ENVIRONMENTAL SEALS MUST BE MAINTAINED. THE USER/INSTALLER
MUST AVOID INSTALLATIONS WHERE AGGRESSIVE SUBSTANCES MAY BE PRESENT AND COULD AFFECT THE
PERFORMANCE OF THSE MATERIALS. CARE MUST ALSO BE EXERCISED WHEN REMOVING AND REPLACING
THE COVER, SO NO MARRING, SCRATCHING OR DAMAGE OCCURS TO THE FLANGES, AND THAT THE FLANGE
SURFACES REMAIN COMPLETELY CLEANED OF DEBRIS.
CAUTION: IF THE UNIT WAS SUPPLIED WITH A GASKET, AVOID FOLDING, CUTTING OR TEARING THE GASKET.
DAMAGING THE GASKET CAN ALLOW MOISTURE TO ENTER THE ENCLOSURE AND DAMAGE THE UNIT.
PREVENTATIVE MAINTENANCE
No scheduled preventative maintenance is required for the LP II Series units when properly applied and installed
correctly. There is no cleaning required for the unit before or during installation.
If the cover is removed after the unit has been in service, it is recommended to replace the gasket to prevent the ingress
of water or dust. At a minimum the gasket should be inspected for folds, cracks, and tears.
VIII. TROUBLESHOOTING
CAUTION: PROPER AND SAFE OPERATION REQUIRES THE UNIT TO BE SECURELY MOUNTED TO THE VESSEL
AND WRENCH TIGHTENED. THE COVER MUST BE PROPERLY INSTALLED WHEN POWER IS APPLIED.
DIAGNOSTICS
The new LPII single rod has extensive built-in diagnostic routines. If any part of the electronics malfunctions, the unit will
detect the problem and indicate it by flashing the GREEN LED. The unique codes are listed in the table below.
18
www.bindicator.com
LVP180914 Rev. D