Set-Up - Bindicator Pulse Point II Series Installation & Operation Manual

VI.

SET-UP

WARNING: HIGH VOLTAGE PRESENT.
REMOVE POWER FROM THE UNIT BEFORE INSTALLING, REMOVING, OR MAKING ADJUSTMENTS.
CAUTION: TO REDUCE THE RISK OF IGNITION IN HAZARDOUS ATMOSPHERES, DISCONNECT THE
EQUIPMENT FROM SUPPLY CIRCUIT BEFORE OPENING. KEEP ASSEMBLY TIGHTLY CLOSED WHEN IN
OPERATION.
OPERATION
The LP II does not require calibration. When power is applied to the unit, the rod will begin vibrating (if the rod is not
impeded by contact with material or some other object). The green Power LED will be illuminated whenever power is
applied to the unit. The status of the red Alarm LED is determined by the selected fail-safe mode and whether or not the
rod is vibrating. Refer to Fail-Safe Selection section.
PRODUCT OVERVIEW - STANDARD MODEL
Figures 3 and 8 show the electronics of the integral and remote
versions of the LP II respectively. The figures show the location
of the electrical connections, dip switch SW1, and the Power and
Alarm LEDs. This section will discuss configuration for optimum
performance in a given application. The settings are controlled by
SW1 as shown in Figure 11.
PRODUCT OVERVIEW - ADVANCED MODEL
Figures 4 and 9 show the electronics of the integral and remote
versions of the LP II respectively. The figures show the
location of the electrical connections, dip switch SW5,
two rotary switches SW3 and 4, and the Power and Alarm
LEDs. This section will discuss configuration for optimum
performance in a given application. The settings are
controlled by SW3 through 5 as shown in Figure 12.
Figure 11: Option Selection Switch, Standard
Figure 12: Option Selection Switch, Advanced
14
www.bindicator.com
LVP180914 Rev. D